Analog Flavor
The analog flavor control is used to adjust how the input and output behaves (or
doesn’t behave) when it is overdriven. To access this control, click on the small but-
ton to the left of the Analog switch to see the analog flavor pop-up menu. For best
results, experiment with different sources when tweaking this control:
Clean: Maximum non-distorted range, with fairly hard clipping.
Fat: Smooth low-frequency distortion.
Squash: Similar to above but more compressed.
Dirt: Smooth broadband saturation.
Crunch: Exaggerated high-end clipping.
Shred: Lots of asymmetrical clipping.
Pump: Extreme pumping compression.
Input and Output Level
The Input and Output level controls are used to (you guessed it) boost or attenuate
either the input or output of FilterFreak. The default setting of the controls approxi-
mates “unity gain” (what goes in comes out the same level) and should provide the
best overall “normal” sound quality when set to these levels. The LEDs beneath the
Input and Output knobs provide visual display of the input and output signal levels.
The yellow LED indicates that the signal is 6dB below clipping. The red LED indicates
maximum signal level, and possible clipping which may or may not sound so good
depending on the switch setting and what your ears like to hear.
These controls are particularly useful in the Analog mode, allowing you to control the
amount of saturation and distortion in FilterFreak. You can crank either the Input or
the Output to create distortion and cranking both to extreme levels can really futz
with your sound.
Distortion combined with filtering can be lots of fun. If you saturate the input stage
(by turning up the Input level), the distortion and harmonics added by the saturation
will be filtered by the FilterFreak filter. If you saturate the output stage by turning up
the Output level, the signal will be filtered first and the distortion and harmonics will
be added post filtering. These can sound quite different and there are a lot of varia-
tions available using both input and output saturation at different levels.
It’s important to note that the input and output level
only affects the filtered signal
and leaves the dry signal unchanged. This approach may be slightly different than
that of some other plug-ins and we found this implementation to work best for
FilterFreak.
20
Содержание FilterFreak
Страница 1: ......
