1.800.338.7337 / www.soundoffsignal.com
1
7X3 POLYCARB_WARNING 1121
!
WARNING
This product contains high intensity LED devices.
To prevent eye damage, DO NOT stare into the
light beam at close range.
P SERIES 7X3 - WARNING LIGHT
EPSSC0JX(x)-(x) - STUD MOUNT
EPSSC0JY(x)-(x) - SCREW MOUNT
•HIGH CURRENT interconnects must be properly terminated. Poor crimp quality can cause heat build-up and fire. Follow crimp
connector manufacturer instructions.
•DO NOT install this product or route any wires in the Air Bag Deployment Zone. Refer to vehicle Owner’s Manual for deployment zones.
•Unit may become hot to touch during normal operation.
•Failure to properly install connectors, fuses or wiring may cause vehicle failure or fire.
•Installation must only be performed by trained technician. Installer must determine vehicle wiring configuration and proper integration of
system.
•Use proper wire gauge. All power wires connecting to positive (+) or negative (-) battery terminal or local chassis ground (-) must be
sized to supply at least 125% of max. current and properly fused at power source.
•Install protective grommets when routing wire through firewall or metal.
WARNING
NOTICE:
Installers and users must comply with all applicable federal, state and local laws regarding use and installation of warning devices.
Improper use or installation may void warranty coverage.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at
www.soundoffsignal.com/tech-services/returns/
.
If you have questions regarding this product, contact
Technical Services
, Monday - Friday, 8 a.m. to 5 p.m. ET at
1.800.338.7337
(press #4).
Questions or comments that do not require immediate attention may be emailed to
ENHANCING SAFETY THROUGH INNOVATION
P SERIES 7X3 WARNING LIGHT
TECHNICAL SPECIFICATIONS
Input Voltage:
9-32Vdc
WARNING LIGHT
CURRENT CONSUMPTION (Amps)
12.8Vdc
25.6Vdc
Peak
Average
Peak
Average
Red
1.55
0.78
0.78
0.39
Amber, Blue,
Green or
White
1.90
0.95
0.95
0.48
AFTER POWER IS ON
, touching the WHITE wire to the ground
will allow you to change various settings on the module. (refer to
page 7).
NOTE: It is recommended to use the Stud Mount
option for any dynamic mount surfaces (i.e.
Swinging Panels, Doors, and Tail Gates).
Protected by U.S. Patent 10,703,260 and Patents Pending
https://soundoffsignal.com/legal/patent-notification/
