SoundCraft SPIRIT POWERSTATION, Руководство пользователя

Страница: 16 / 37

4 AUXILIARY SENDS
These controls route the input channel signal in mono to any
one or more Auxiliary busses. These are separate from the
main outputs and can therefore provide additional outputs
for foldback, echo units or extra loudspeaker ‘fills’, or provide
a dedicated mix to the on-board Lexicon Digital Effects
Processor.
AUX 1 is normally POST-FADE, and will therefore fade up
and down with the fader, which is useful for effects. By
pressing the AUX1 PRE switch on the Master section, the
AUX 1 send is set PRE-FADE, and will be independent of the
fader which is important for foldback or monitor feeds. The
knob should be turned down when not in use.
The AUX 2 control is always POST-FADE, and may be
switched between the Aux 2 buss or, by pressing the
LEXICON switch, feeds the channel signal to the Effects bus.
The knob should be turned down when not in use.
5 LEXICON SWITCH
This switch, when pressed, enables the post-fade Aux 2
control to send the chanel signal to the Lexicon Digital Effects
Processor on the right hand side of the console.
6 BALANCE
The BAL (Balance) control determines the position of the
signal within the stereo mix image. Rotation fully
anticlockwise feeds the signal solely to the Left mix buss,
while rotation clockwise sweeps the image to the Right buss.
7 PFL
When the PFL switch is pressed, the pre-fade signal is fed in
stereo to the monitor, where it is available as a switched
choice of sources for the headphones or meters (see Master
Section). This is a useful way of listening to any required
input signal without interrupting the main mix, for making
adjustments or tracing problems.
8 CHANNEL FADER
This linear fader determines the proportion of the channel in
the mix and provides a clear visual indication of channel
level. Normal operating position is at the ‘0’ mark, providing
10dB of gain above that point if required.
Page 15