SoundCraft SPIRIT POWERSTATION, Руководство пользователя

Страница: 14 / 37

7 AUXILIARY SENDS
These controls route the input channel signal to any one or
more Auxiliary busses. These are separate from the main
outputs and can therefore provide additional outputs for
foldback, echo units or extra loudspeaker ‘fills’, or provide a
dedicated mix to the on-board Lexicon Digital Effects
Processor.
AUX 1 is normally POST-FADE, and will therefore fade up
and down with the fader, which is useful for effects. By
pressing the AUX1 PRE switch on the Master section, the
AUX 1 send is set PRE-FADE and PRE-EQ, and will be
independent of the fader which is important for foldback or
monitor feeds. The knob should be turned down when not in
use.
The AUX 2 control is always POST-FADE, and may be
switched between the Aux 2 buss or, by pressing the
LEXICON switch, feeds the channel signal to the Effects bus.
The knob should be turned down when not in use.
8 LEXICON SWITCH
This switch, when pressed, enables the post-fade Aux 2
control to send the chanel signal to the Lexicon Digital Effects
Processor on the right hand side of the console.
9 PAN
The PAN control determines the position of the signal within
the stereo mix image. Rotation fully anticlockwise feeds the
signal solely to the Left mix buss, while rotation clockwise
sweeps the image to the Right buss.
10 PFL
When the PFL switch is pressed, the pre-fade signal is fed
equally to both sides of the monitors, where it is available as a
switched choice of sources for the headphones or meters (see
Master Section). This is a useful way of listening to any
required input signal without interrupting the main mix, for
making adjustments or tracing problems.
11 CHANNEL FADER
This linear fader determines the proportion of the channel in
the mix and provides a clear visual indication of channel
level. Normal operating position is at the ‘0’ mark, providing
10dB of gain above that point if required.
Page 13