Sound Devices MixPre-10T, Руководство пользователя

Страница: 23 / 65

23
INPUTS
Gain Staging with Linking
You can use linking with single gain stage or two-gain stage (trim/fader)
operation.
For instance, users wanting to link inputs 1-2 or 1-4, but control all levels from
the front-panel Channel 1 knob should set System > Mode to Custom and then
in Custom Setup, set Gain to Basic and Channel to Advanced.
Users wanting to link those same inputs but use two gain stages should use
Advanced Mode or Custom mode with both Gain and Channel set to Advanced.
Then, you can adjust trim gain levels for linked channels from the Channel 1
screen and adjust fader levels for linked channels with the Channel 1 knob.
Setting Input Delay
Input delay may be used to compensate for ‘phasey’ sounding audio because
of time-of-arrival differences between sound sources, such as a boom mic and
wireless radio mic picking up the same sound source.
To set a channel’s input delay:
1. Push in the channel’s knob to access its Channel screen.
2. On page 3, tap Delay.
3. Tap the arrows or use the encoder to adjust the setting. Each channel can
be delayed up to 30ms.
The delay is applied before the signal is sent to the recorder and outputs.
L
Input Delay is not available in Basic mode.
Inverting Phase
Phase inversion (or polarity reversal) is used to compensate for incorrectly
wired, balanced cables, to prevent signal cancellation when a source is dual-
mic’d from opposite directions, or to reverse left/right with microphones in a
mid-side (MS) configuration.
To invert a channel’s phase:
1. Push in the channel’s knob to access its Channel screen.
2. On page 2, tap Phase to set it to Invert.
L
Phase Inversion is not available in Basic mode.