If you select Gain and press SET, on the display you will see the following screen
the Eth led will be turned on because the system sends a message to DPA880T asking for the
current status of the gain on the selected input.
If the CP8 is not connected to the DPA880T or the ID is not correct then the display will show the
following message
and after 2 sec. The Eth led will turn off and the system will go back to the menu
If communication is successful, then the display will show the current status of Gain
...
...
through Encoder it is possible to change the Gain value (Gain varies between-127.0 dB to + 12dB)
and in real-time the parameter will be updated on DPA880T
Using Encoder it is possible to change the gain variation in steps of 0.1 dB or 1dB
Press the Esc key to return to the start screen
2.
SELECT OUTPUT
After pressing the SET button, via Encoder you can select between Output 1 - 8.
.............
Gain [dB]
Step=0.1dB G=
Gain [dB]
Step=0.1dB G=-
127.0
Gain [dB]
Step=0.1dB G=0.0
Input 2
Gain
Input 2
Gain
Gain [dB]
Step=0.1dB
G=+12.0
CP8 CTRL PANEL
Select Output
Select Output
Output 1
Select Output
Output 2
Select Output
Output 8
Gain [dB]
Device not connected
