•
Select Routing
: Using this menu, it is possible to select the input to be associated with the
selected zone, here it is possible to vary the mute (if the selected input is enabled on the
zone) and gain (% selected on input area)
•
Select Zone
: Using this menu, you can configure the Volume and Mute for the Zone
•
Info
: Via this menu is possible to display the model, version and ID set
•
Lock
: Through this menu it is possible to put CP8 in Lock
1.
SELECT ROUTING
After pressing the SET button,
the Eth led will turn on because the system sends a message to DPA880T asking for the current
status of the Routing of the Zone
If the CP8 is not connected to the DPA880T or the ID is not correct then the display show the
following message
and after 2 sec. The Eth led will turn off and the system will go back to the menu
If communication is successful, then the display will show the selection and using the Encoder you
can select between Input 1 - 8.
.............
After selecting an entry (eg. Input2) and press the SET button,
It is possible to select by using the Encoder, the Mute (enable/disable input areas) or Gain (% input
on Zone) parameters
If you select Mute and press SET, on the display you will see the following screen
Select Routing
Input 1
Select Routing
Input 2
Select Routing
Input 8
Input 2
Mute
Input 2
Gain
CP8 CTRL ZONE_
Select Routing
CP8 CTRL ZONE_
Select Routing
Select Routing
Device not connected
Mute
Mute = Off
Mute
Mute = On
