User Manual
CP8
Rev1.0
Connection type: RS-485
The CP8 communication to the DPA880T is by RS485. +1 and -2 are only required pins from the
RJ45
Power Supply
Power supply DC +12V is required to power the CP8 (not supplied with the panel)
To programme CP8:
CP8 you can set user defined as either Master Mode or Zone ModeUser. The following instruction
explains the process
−
"Set" button is used to access the various menus and to confirm
−
"Esc" button is used to exit from the menus
−
"Encoder" The large rotary encoder is used to enter and exit the standby mode if the key is
pressed for around 5-6 sec. Or with the single press allows setting the steps for changing
the values of Gain and Volume (Gain =-127dB to + 12dB; Volume =-127dB to + 18dB)
−
The Encoder is also used to move between the various menus and changing the values of
the parameters.
−
LCD display 2 x 20 alphanumeric
−
Power ON Led: when lit indicates that the system is powered
−
Eth Led: when lit indicates that the CP8 is communicating with the DPA880T
