9
Front left
a
NETWORK TRUNK connector (RJ-45 8-pin)
Connects a device connected to the CCU’s NETWORK
TRUNK connector to the network.
b
RET 1 (return video 1) button
The return video 1 signal from the camera control unit is
monitored on the viewfinder screen while this button is
pressed. It functions the same as the RET 1 buttons on the
handle
and on the operation panel on the rear of the
camera
(page 10 (JN/SY models) or page 11 (CE/CN
models))
.
You can also assign other functions to this button, using the
menu displayed on the viewfinder screen.
c
MIC 1 IN (microphone 1 input) connector (XLR 3-pin)
Connect a microphone.
This connector and the AUDIO IN CH1 connector
on the connector panel on the rear of the camera are
alternately activated with the CH1 audio input select switch
d
MIC (microphone) power switch
+48V:
To supply power at +48 V to the microphone connected
to the MIC 1 IN connector.
OFF:
Not to supply power to the microphone connected to the
MIC 1 IN connector.
e
SHUTTER switch
For setting the electronic shutter functions when the camera is
used in standalone status without connecting a camera control
unit.
OFF:
The electronic shutter does not function.
ON:
The electronic shutter is activated.
SEL:
The shutter speed and shutter mode change each time
the switch is set to this position.
For details, see “Setting the Electronic Shutter” on page 20.
f
INTERCOM LEVEL control
To adjust the intercom/earphone volume level.
The intercom level adjustment is enabled when the
INTERCOM 1 and 2 LEVEL/MIC switches (on the JN/SY-
model operation panel
) or the LEVEL switch (on the
CE/CN-model operation panel
) on the rear of the
camera are set to FRONT.
g
RET 2 (return video 2) button
When this button is pressed, the picture on the viewfinder
screen changes to the return video signal selected with the
RET 2 select switch
(page 10 (JN/SY models) or page 11 (CE/
CN models))
on the operation panel on the rear of the camera.
You can also assign other functions to this button, using the
menu displayed on the viewfinder screen.
Rear
a
DC power supply out connector (2-pin)
Supplies power to an external device up to 2.5 A.
b
CAMERA POWER switch
CCU:
Power is supplied from the camera control unit.
EXT:
Power is supplied through the DC IN connector.
c
Tally lamp and switch
ON:
The tally lamp lights when a tally signal is input to the
connected camera control unit or a call signal is
generated in response to pressing the CALL button.
OFF:
The tally lamp is prevented from lighting.
d
BPU (Baseband Processor Unit) connector (optical/
electrical multi-connector)
Connect to BPU4000 Baseband Processor Unit using an
optical/electrical multi cable.
e
SDI 1 (serial digital interface 1) connector (BNC-type)
For 3G-SDI, HD-SDI or HD PROMPTER signal output.
b
c
d
e
a
f
g
b
c
Operation panel
d
a
f
e
g
h
Connector panel
