7. Install the drive.
To install the drive, position the drive in the drive bay
so that the screw holes of the drive are aligned with the
screw holes in the drive bay. Then tighten the screws
until they are firm. Do not over tighten the screws.
CD-RW Recorder User’s Guide
21
The drive comes pre-configured as an IDE Master device as
shown below with the Master pin jumpered.
If the drive is the only drive on the EIDE port then the drive
should be the master drive. To make the Drive the master drive
you put the jumper block on the Master pin position
If the drive will be using the same port with a hard drive, then
the hard drive should be set as the master and the drive as the
slave drive. To make the drive the slave drive you put the
jumper block on the Slave pin position.
20
CD-RW Recorder User’s Guide
C
S
R G G L
+5 G G +12
0 0
S
L
M
A
39
40
1
2
Audio
Output
Master Pin
Jumpered
Slave pin (open)
Pin 1
DC Power
Connector
IDE ATAPI
40-pin Connector
Cable Select
Slave
Master
Cable Select
Slave
Master
DIGITAL
AUDIO
ANALOG
AUDIO
SLAVE
C
S
R G G L
+5 G G +12
0 0
S
L
M
A
39
40
1
2
MASTER
HOST INTERFACE
POW
ER
CABLE SELECT
