88
en | Configuration
Network camera
2019-07 | V01 | DOC
User manual
Sony Corporation
2.
Enter new scripts in the Alarm Task Editor field or change existing scripts in line with your
requirements.
3.
When finished, click
Set
to transmit the scripts to the device. If the transfer was
successful, the message
Script successfully parsed.
is displayed over the text field. If it
was not successful, an error message is displayed with further information.
4.6
Interfaces
(Only applicable to SNC-EMX cameras)
4.6.1
Alarm Inputs
Active
Configure the alarm triggers for the unit.
Select
N.C.
(Normally Closed) if the alarm is to be triggered by opening the contact.
Select
N.O.
(Normally Open) if the alarm is to be triggered by closing the contact.
Name
Enter a name for the alarm input. This is then displayed below the icon for the alarm input on
the
Live
page (if configured).
Action
Select a type of action to be performed when an alarm input occurs:
–
None
–
Monochrome
This switches the camera to the monochrome mode.
–
Switch mode
When this is selected, you can select the
Scene Mode
to be used for the active and
inactive period of the alarm.
4.6.2
Alarm Outputs
Configure the switching behavior of the output.
Select different events that automatically activate an output. For example, turn on a floodlight
by triggering a motion alarm and then turn the light off again when the alarm has stopped.
Idle state
Select
Open
for the output to operate as a normally open contact, or select
Closed
if the
output is to operate as a normally closed contact.
Operating mode
Select the way the output works.
For example, if you want an activated alarm to stay on after the alarm ends, select
Bistable
. If
you wish an activated alarm to stay on for ten seconds for example, select
10
s
.
Output follows
Select the event that triggers the output.
Output name
The alarm output can be assigned a name here. This name appears on the Live page.
Toggle
Click the button to switch the alarm output manually (for example, for testing purposes or to
operate a door opener).
4.7
Network
The settings on these pages are used to integrate the device into a network. Some changes
only take effect after a reboot. In this case
Set
changes to
Set and Reboot
.
Содержание SNC-EMX30
Страница 274: ......
Страница 275: ... Bosch Security Systems B V 2019 2019 07 V01 ...
