![background image](http://html.mh-extra.com/html/sony/rm-vl900/rm-vl900_operating-instructions-manual_417755048.webp)
48
Troubleshooting (continued)
Symptom
The S (set) indicator or
the Component Select
buttons flash five times
All Component Select
buttons flash twice
during an operation
A System Control
program does not
function correctly.
All Component Select
buttons flash twice
Your Commander does
not work as expected
after Data Transfer
Remedy
• Learning has not succeeded. See “For accurate Learning”
(page 18) and try the Learning procedure again (page 15).
• The component codes cannot be set. See the supplied
“Component Code Numbers” and try setting the component
codes again (page 8).
• The data have not been transferred. See “Transferring the
data” (page 38) and try transferring the data again.
• The data have not been received. See “Receiving the data”
(page 40) and try receiving the data again.
• Clear infrequently used Learned functions (page 19), then
carry out learning operations.
• Signals have been programmed for that Component Select or
SYSTEM CONTROL button using the Learning function.
Clear the “learned” signals (pages 19, 26, 28) and try
programming the System Control function again.
• Signals have been programmed for that Macro key using the
Learning function. Clear the “learned” signals (page 19) and
try programming the Channel Macro function for the same
key again, or try with another Macro key.
• Make sure that you have programmed the commands in the
correct order (pages 24, 27).
• Try changing the orientation of the Commander. If that does
not help, try placing the components as close to each other as
possible.
• Check the status of the components and make sure that you
have set the components properly to receive commands (page
27).
• The component code is changed or a new signal is “learned”
on a button that has been programmed in the series of
commands. In this case, the new signal is transmitted when
the series of commands are executed.
• The interval may be too short. See “Changing the interval
between operation steps” (page 29) and set a longer interval.
• The Hold function is on. Unlock the Hold function (page 45).
• Data Transfer to/from a single button cannot transfer System
Control functions that are “learned” by Component Select
buttons. Either set up the “learned” Commander from the
start, or perform whole Data Transfer.
Note on Commanders with the
mark
Data Transfer between Commanders with the
mark may not always be complete,
depending on their functions and keys, and some of the System Control function
data may be dropped.