![background image](http://html.mh-extra.com/html/sony/rm-vl900/rm-vl900_operating-instructions-manual_417755040.webp)
40
5
Press ENT (Start data
transfer).
After the data is transferred,
the Component Select button
turns off.
If data transfer has been
unsuccessful during or after
procedure, the S (set) indicator
and the selected Component
button flashes five times, and
the Commander returns to its
state in Step 3. Either try again
from Step 5, or press S (set) to
cancel data transfer.
Notes
• The data of the “learned” signal and
the System Control function
programmed on a Component Select
button cannot be transferred.
You can use the Learning function
(page 15) to program the “learned”
signal and the System Control
function programmed on a
Component Select button on another
remote commander.
• Be sure that the receiving remote
commander is ready to receive data.
Receiving the data
This Commander can receive the
data of another Sony RM-VL900 or
RM-AV2100.
To receive the all data from
another remote commander
1
Place the RM-VL900 head
to head with another
remote commander.
2
Press and hold S (set) for
more than 3 seconds.
The S (set) indicator lights up,
and all Component Select
buttons flash.
Another remote
commander
RM-VL900
about 2 – 4 inches
(5 – 10 cm) away
Transferring Data between
Remote Commanders
(continued)