000
20
2. Preparation
Preparing a Power Supply
For safety, use only the Sony battery packs and AC
adaptors listed below.
ˎ
ˎ
BP-FLX75 Lithium-ion Battery Pack
[CAUTION]
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
When you dispose of the battery, you must obey the law in
the relative area or country.
Using a Battery Pack
Press the battery pack against the back of the
camcorder, aligning the line on the side of the
battery pack with the line on the camcorder. Then
slide the battery pack down until its “LOCK” arrow
aligns with the line on the camcorder.
To detach the battery pack, pull the battery pack
up by holding the release button in.
[Notes]
ˎ
ˎ
If the battery pack is not attached correctly, the terminals
may become damaged.
ˎ
ˎ
During recording and playback (while the ACCESS lamp
on the right-side panel is lit in blue and the ACCESS lamp
in the card slot section is lit in orange), be careful never to
remove the battery pack.
Doing so may corrupt the data recorded on the card.
ˎ
ˎ
Make sure to power the camcorder off before replacing
the battery pack.
When a BP-FLX75 Battery Pack is used, the
camcorder will operate continuously for
approximately 150 minutes.
[WARNING]
Batteries shall not be exposed to excessive heat
such as sunshine, fire or the like.
[Note]
The battery pack operating time depends on the frequency
of use of the battery pack, and the ambient temperature
when used.
Before use, charge the battery pack with a charger
suitable for each battery.
For details on the battery charging procedure, refer to the battery
charger operation manual.
Note on using the battery pack
A warm battery pack may not be able to be fully
recharged.
Using AC Power
Mount an AC-DN2B/DN10 on the camcorder in
the same way as a battery pack, then connect to
the AC power supply.
