Sony pavit AZ-BS1, Руководство по эксплуатации

Страница: 23 / 28

23
Additional information
Troubleshooting
If you experience any of the following difficulties while using your player, use this
troubleshooting guide to help you to remedy the problem. Should any problem persist, consult
your nearest Aiwa dealer.
For trouble concerning operations while connected to your computer, also refer to
“Troubleshooting” in the separate manual “Music Transfer pavit Edition.”
Operation
Symptom
There is no sound.
The display becomes hard to
see or nothing is displayed.
The sound is distorted.
Playback stops suddenly or
the volume is reduced.
There is noise in the
playback sound.
Erroneous display.
The upper part of the “pavit”
insertion indicator “
”
flashes.
Cause/Remedy
c
The volume level is set to the minimum level.
Increase the volume (page 11).
c
The “pavit” is not inserted in the player correctly.
Reinsert the “pavit” and check if the “pavit” insertion indicator
“
” is displayed (page 10).
c
The player contains moisture condensation.
Let your player sit for a few hours at room temperature.
c The batteries are exhausted.
Replace the batteries with new ones (page 7).
c
The bit rate used when encoding the MP3 files was low.
Send MP3 files encoded with higher bit rates to the “pavit.”
c
The batteries are exhausted.
Replace the batteries with new ones (page 7).
c
The music data itself contains noise.
Noise may have been introduced when creating music data due to
the conditions of the computer. Create the music data again.
c
The player is not functioning normally.
Remove the “pavit” from the player, and then press and hold
Nx /POWER for more than 10 seconds to reset the player.
c
Send the music data to the “pavit” again, as the data stored in the
“pavit” may have been destructed.
c
The “pavit” does not have any music data, or the music data stored
in the “pavit” may be destructed.
Send the music data to the “pavit” again.
(Continued)