Pre
par
at
ion
Assigning the IP Address to the Unit
13
To specify the IP address manually:
Select
Use the following IP address
, and type the
IP address, Subnet mask and Default gateway in the
relevant boxes.
Note
When you select
Obtain an IP address
automatically
, make sure that the DHCP server is
operating on the network.
8
Set the DNS server address.
To obtain the DNS server addresses
automatically:
Select
Obtain DNS server address automatically
.
To specify the DNS server addresses manually:
Select
Use the following DNS server address
, and
type the Primary DNS server address and
Secondary DNS server address in the relevant
boxes.
Note
The Third DNS server address and Fourth DNS
server address are invalid for this camera.
9
Set the HTTP port No.
Normally, select
80
for the HTTP port No. To use
another port number, type the port number between
1024 and 65535 in the text box.
10
Type the Administrator name and Administrator
password.
The factory settings of both items are “admin.”
Note
You cannot change the Administrator name and
Administrator password in this step. To change
these items, see “Setting the User – User setting
Page” on page 39.
11
Confirm that all items are correctly set, then click
OK
.
If “Setting OK” is displayed, the IP address is
correctly assigned.
12
To access the unit directly, double-click the unit
name in the list.
The welcome page is displayed in the Web browser.
Note
If the IP address is not set correctly, the welcome page
does not appear after step 12. In that case, try to set the
IP address again.
