12
Basic Operation
Recording
After connecting the NEX-FS700 series,
you are ready to record on this unit.
1
Make sure that the necessary
devices (NEX-FS700 series, etc.)
are connected, and that power is
supplied to them.
For details about connecting the
devices, see page 8.
2
Load a memory card into the
AXS-R5.
3
Change the setting of the
NEX-FS700 series as follows.
1
Press the MENU button on the
NEX-FS700 series.
2
Turn the SEL/PUSH EXEC dial on the
NEX-FS700 series and select
(REC/OUT SET)
t
[REC SET]
t
[
/
/
SET]
t
[
].
4
Set the POWER ON/OFF switch of
the unit to ON.
The power of the unit is turned on.
5
Perform recording movies.
Record by operating the NEX-FS700
series
Press the START/STOP button on the
NEX-FS700 series.
Record by operating the unit
Press the two REC buttons
simultaneously on the unit.
Stop recording by operating the NEX-
FS700 series
Press the START/STOP button again.
• You can start/stop recording by pressing the
START/STOP button when the [REC
TRIGGER] is set to [SDI RMT] (default
setting) (p. 15).
Stop recording by operating this unit
Press the
x
/STOP button.
• When you stop recording, video, audio and
subsidiary data from the start to end of the
recording are recorded as a single clip on the
memory card.
Recording in 4K-120p or 4K-100p
Set [REC TRIGGER] to [SDI RMT], then
press the START/STOP button on the
NEX-FS700 series to start recording.
b
Notes
• The recorded clip is divided by the amount set
in [CHUNK]. However the divided clips are
identified as the same single clip.
• If the signal from the NEX-FS700 series is
interrupted, recorded data will be corrupted. Do
not remove the BNC cable, turn the NEX-FS700
series off or change the recording mode while
recording.
• If the battery pack or AC adaptor connector is
removed from the AXS-R5 during recording,
the recorded data at the time the power is turned
off may not be recorded correctly.
• When [TC RUN] is set to [REC RUN] on the
NEX-FS700 series and recording is started by
the REC button on this unit, even if the AXS-R5
and NEX-FS700 series start recording at the
same time, the time code may be different in a
clip recorded to the AXS-R5 and the clip
recorded in the NEX-FS700 series.
z
Tips
• The maximum clip length is 24 hours.
• For details on other settings, see the operating
guide of the NEX-FS700 series camcorder.