HT-S200F/SF200/SF201
27
Gain adjust:
1. While entered state to the AMP test mode, press the [VOICE]
buttons on the remote control.
2. The gain adjust mode is entered, and the LEDs light up/
fl
ash as
shown in the following
fi
gure (Refer to “Gain values display”
below).
3. Each time the [VOICE] button on the remote control is pressed,
gain value increase. Each time the [NIGHT] button on the re-
mote control is pressed, gain value decrease (Refer to “Gain
values display” below).
4. Perform other AMP test items or release the AMP test mode.
Gain values display:
Gain value: +1.0
light up
flash
Gain value: +0.9
light up
flash
Gain value: +0.8
flash
Gain value: +0.7
light up light up
light up
Gain value: +0.6
light up
light up
Gain value: +0.5
light up
light up
Gain value: +0.4
light up
Gain value: +0.3
light up light up
Gain value: +0.2
light up
Gain value: +0.1
light up
Gain value: 0
(All light off)
Gain value: –0.1
light up light up
flash
Gain value: –0.2
flash
Gain value: –0.3
flash
light up
Gain value: –0.4
flash
light up
Gain value: –0.5
flash
light up
light up
Gain value: –0.6
flash
Gain value: –0.7
flash
light up
Gain value: –0.8
light up
flash
Gain value: –0.9
light up
flash
light up
Gain value: –1.0
light up
flash
flash
IR repeater setting:
1. While entered state to the AMP test mode, press the [
V
] button
on the remote control.
2. The IR repeater setting is turned ON, and the LEDs
fl
ash as
shown in the following
fi
gure.
flash
2 times
IR repeater setting: ON
3. While entered state to the AMP test mode, press the [
v
] button
on the remote control.
– Continued to upper right –
4. The IR repeater setting is turned OFF, and the LEDs
fl
ash as
shown in the following
fi
gure.
flash
1 time
IR repeater setting: OFF
5. Perform other AMP test items or release the AMP test mode.
L/R channel toggle:
1. While entered state to the AMP test mode, press the [STANDARD]
button on the remote control.
2. The L/R/SW channel toggle mode is entered, then the LEDs
light up as shown in the following
fi
gure, and changed to the
R-ch output only setting.
light up
light up
R-ch output only setting
3. Each time the [STANDARD] button on the remote control is
pressed, L/R/SW channel output setting is changed.
(For L-ch/R-ch output only setting, the volume is set to 30. For
SW-ch output only setting, the volume is set to maximum)
light up light up
L-ch output only setting
light up light up light up
SW-ch output only setting
light up
light up
R-ch output only setting
Normal output setting
(Normal display (function LED is
light up))
4. Perform other AMP test items or release the AMP test mode.
SYS SET
2021/02/16 22:34:59 (GMT+09:00)
