Sony HT-M22, Руководство по эксплуатации

Страница: 52 / 68

52
GB
Troubleshooting
If you experience any of the following
difficulties while using the receiver, use
this troubleshooting guide to help you
remedy the problem. Should any problem
persists, consult your nearest Sony dealer.
Note that if service personnel changes
some parts during repair, these parts may
be retained.
The receiver is turned off
automatically.
• “AUTO STBY” is set to “STBY ON”
(page 48).
• The Sleep Timer function is working
(page 11).
• “PROTECTOR” is working (page 58).
No image appears on the TV.
• Select the appropriate input using the
INPUT SELECTOR buttons.
• Set your TV to the appropriate input
mode.
• Move your audio equipment away
from the TV.
• Make sure that cables are correctly and
securely connected to equipment.
• Depending on the playback
equipment, you may need to set up the
equipment. Refer to the operating
instructions supplied with each
equipment.
• Be sure to use a High Speed HDMI
cable when you view images or listen
to sound, especially for the 1080p,
Deep Color (Deep Colour), 4K or 3D
transmission.
No 3D image appears on the TV.
• Depending on the TV or the video
equipment, 3D images may not be
displayed. Check the HDMI video
formats supported by the receiver
(page 60).
No 4K image appears on the TV.
• Depending on the TV or video
equipment, 4K images may not be
displayed. Check the video capability
and setting of your TV and video
device. Also, make sure to connect the
video equipment to 4K available
HDMI IN jack of the receiver.
When the receiver is in standby mode,
there is no image output from the TV.
• When the receiver enters into standby
mode, image is from the last HDMI
equipment selection before you turned
off the receiver. If you are enjoying
other equipment, play the equipment
and perform the One-Touch Play
operation, or turn on the receiver to
select the HDMI equipment you want
to enjoy.
• Make sure “PASS THRU” is set to
“ON” in the HDMI settings menu if
you connect equipment not compatible
with the “BRAVIA” Sync to the
receiver (page 47).
There is no sound, no matter which
equipment is selected, or only a very
low-level sound is heard.
• Check that all connecting cords are
inserted to their input/output jacks for
the respective jacks of the receiver,
speakers and the equipment.
• Check that both the receiver and all
equipment are turned on.
• Check that MASTER VOLUME
control is not set to “VOL MIN”.
Power
Image
Sound