– 29 –
6-9.
ERROR RATE CHECK
6-9-1. CD Error Rate Check
Checking Procedure :
1. Load a check disc (MD) TDYS-1.
2. Press the
[/–]
button to display “CPLAY MODE”.
3. Press the
p
(CD) button to display “CPLAY MID”.
4. “C =
AD =
” is displayed.
5. Check that the C1 error rate is below 20.
6. Press the
^
(CD) button to stop playback. Then press the
6
(MD) button, and remove the check disc (MD).
6-9-2. MO Error Rate Checking
Checking Procedure :
1. Load a continuously recorded disc (Refer to 6-4. Creating the
Continuously Recorded Disc”).
2. Press the
[/–]
button to display “CPLAY MODE”.
3. Press the
p
(CD) button to display “CPLAY MID”.
4. “C =
AD =
” is displayed.
5. Check that the C1 error rate is below 50 and ADER is 00.
6. Press the
^
(CD) button to stop playback. Then press the
6
(MD) button, and remove the disc.
6-10. FOCUS BIAS CHECK
Change the focus bias value and check the focus tolerance amount.
Checking Procedure :
1. Load a continuously recorded disc (Refer to 6-4. Creating the
Continuously Recorded Disc”).
2. Press the
[/–]
button to display “CPLAY MODE”.
3. Press the
p
(CD) button to display “CPLAY MID”.
4. When “C =
AD =
” is displayed, press the
^
(CD)
button.
5. Press the
[/–]
button to display “FBIAS CHECK”.
6. Press the
p
(CD) button to display “
/
c =
”.
The first four digits indicate the C1 error, the two digits after
the “/” indicate ADER and the two digits after “c =” indicate
the focus bias value.
Check that the C1 error is below 50 and ADER is 00.
7. Press the
p
(CD) button to change the display to “
/
b
=
”.
Check that the C1 error does not drop below about 200 and
ADER does not remain above 00.
8. Press the
p
(CD) button to change the display to “
/
a
=
”.
Check that the C1 error does not drop below about 200 and
ADER does not remain above 00.
9. Press the
^
(CD) button, press the
6
(MD) button next,
and remove the continuously recorded disc.
Note 1:
If the C1 error is above about 200 or ADER is above 00 only for
point a (step 8 above) and point b (step 7 above), the focus bias
may not adjusted properly. In this case, adjust again.
Содержание HCD-MD1EX - System
Страница 2: ... 2 ...
Страница 11: ... 11 This section is extracted from instruction manual ...
Страница 44: ...HCD MD1EX 55 56 7 12 PRINTED WIRING BOARD MAIN Board side A See page 41 Circuit Boards Location ...
Страница 93: ...115 HCD MD1EX MEMO ...