![background image](http://html.mh-extra.com/html/sony/hcd-md1ex-system/hcd-md1ex-system_service-manual_420809032.webp)
– 32 –
Procedure :
1. Connect oscilloscpe to test point TP (TEO) on BD (CD) board.
2. Turn Power switch on.
3. Put disc (YEDS-18) in to play the number five track.
4. Press the “
^
(CD) (Pause)” button. (Becomes the 1 track
jump mode)
5. Confirm that the oscilloscope waveform is symmetrical on the
top and bottom in relation to 0Vdc, and check this level.
1 track jump waveform
E-F Balance (1 Track Jump) Check
(Without remote commander)
Specified level: • x 100 = less than ± 7%
• A + B = 300 ± 100 mVp-p
6. Remove the lead wire connected in step 1.
Focus/Tracking Gain Adjustment (RV102, RV103)
This gain has a margin, so even if it is slightly off.
There is no problem.
Therfore, do not perform this adjustment.
Please note that it should be fixed to mechanical center position
when you moved and do not know original position.
A – B
2 (A + B)
Adjustment Location:
[BD (CD) Board] (Side B)
–
+
oscilloscope
BD (CD) board
TP (TEO)
TP (VC)
A
B
0V
LEVEL : 300
±
100 mVp-p
RF
RV101
(Focus Bias
Adjustment)
(Focus/Tracking Gain Adjustment)
RV103
TEO
VC
FEO
RV102
TEI
FEI
FOK
IC101
IC104
GND
PCK
IC102
Содержание HCD-MD1EX - System
Страница 2: ... 2 ...
Страница 11: ... 11 This section is extracted from instruction manual ...
Страница 44: ...HCD MD1EX 55 56 7 12 PRINTED WIRING BOARD MAIN Board side A See page 41 Circuit Boards Location ...
Страница 93: ...115 HCD MD1EX MEMO ...