Sony Handycam DCR-PC10, Руководство по обслуживанию

Страница: 120 / 181

5-48
2. PLL fo Adjustment (MR-39 Board)
Mode VTR stop
Measurement Point The displayed data of address : 04 on
Measuring Instrument page : 3
Adjustment Page C
Adjustment Address 3D, 3C
Specification Value The displayed data is in the range
from FD to FF, or in the range from
00 to 03.
(FF and 00 are the center values.)
Adjustment procedure:
Processing after Adjustments:
Order Page Address Data Procedure
1 0 01 01 Set the data. (Preparation)
2 3 01 05 After setting the data, press the PAUSE button.
3 3 36 04 After setting the data, press the PAUSE button.
4 3 04 Take reading of the displayed data of address : 04 on page : 3 several times and take the
average value which is taken as D
04
. Confirm that D
04
is in the range from “FD” to “FF” or
from “00” to “03”.
5 C 3C If D
04
is not in the specified range in step 4, adjust the data of address : 3C on page : C as
follows and check the result again.
[When D
04
is in the range from 80 to FC]
Decrease the data of address : 3C on page : C.
(To write the data, press the PAUSE button of the adjustment remote commander after data
is changed.)
[When D
04
is in the range from 04 to 7F]
Increase the data of address : 3C on page : C.
(To write the data, press the PAUSE button of the adjustment remote commander after data
is changed.)
6 3 36 05 After setting the data, press the PAUSE button.
7 3 04 Confirm that the average data D
04
of address : 04 on page : 3 is in the range from “FD” to
“FF” or from “00” to “03”.
8 C 3D If D
04
is not in the specified range in step 7, adjust the data of address : 3D on page : C as
follows and check the result again.
[When D
04
is in the range from 80 to FC]
Decrease the data of address : 3D on page : C.
(To write the data, press the PAUSE button of the adjustment remote commander after data
is changed.)
[When D
04
is in the range from 04 to 7F]
Increase the data of address : 3D on page : C.
(To write the data, press the PAUSE button of the adjustment remote commander after data
is changed.)
Order Page Address Data Procedure
1 3 36 02 After setting the data, press the PAUSE button.
2 3 01 00 After setting the data, press the PAUSE button.
3 0 01 00 Set the data. (End)