GTK-XB90
15
2-15. FRONT PANEL BLOCK-1
• Continued on 2-16 (page 16).
3
Align the front panel block and box unit
around the boss, insert a jig between
them, and open a gap of about 3 to 5
mm (perform at the top, bottom, left,
and
right).
Note
1:
When using a jig, please work carefully
so as not to damage the front panel
block and box unit.
total ten bosses
(with bond)
bottom side
top side
1
two screws
(M4
u
20)
front panel block
– Top view –
– Bottom view –
5
Insert a thick screwdriver into the bottom side
and widen the gap (perform at two places).
Note
2:
A screwdriver is inserted too far in, the
speaker unit (WF) may get damaged.
Note
3:
Do the work from the bottom side rather
than the side.
4
Insert a thick screwdriver into the top side and
widen the gap (perform at two places).
Note
2:
A screwdriver is inserted too far in, the
speaker unit (WF) may get damaged.
Note
4:
Do the work from the top side rather
than the side.
1
two screws
(M4
u
20)
box unit
about
3 to 5 mm
boss
(with bond)
front panel block
front side
Note 3:
This boss is
only US and
CND
models.
Note 3:
This boss excludes US and CND models.
2
claw
2
claw
– Side view –
SYS SET
2020/08/20 22:42:53 (GMT+09:00)
