Sony EXWAVEPRO SNC-CM120, Руководство по обслуживанию

Страница: 26 / 64

2-12
SNC-CS20/CM120
2-3-5. VSUB Voltage Check
(Only SNC-CM120)
1. Connect to this unit via browser and set “Light funnel
mode” to Always ON from the [Camera]-[Sense up]
tab in the setting window.
2. Shoot an arbitrary image and check that the image is
output correctly.
3. After the check, return “Light funnel mode” to the
original setting.
2-4. Procedure for SY-365/365A Board
Replacement
When replacing the SY-365/365A board, perform the
following procedure.
.
Replace the old MAC address label with the new one.
(Section 2-4-1)
.
Rewriting of MAC address and serial number
(Section 2-4-2)
2-4-1. Re-sticking of MAC Address Label
Replace the MAC address label on the bottom of the unit
with the new label supplied with the new SY-365/365A
board.
2-4-2. MAC Address and Serial Number
Writing
Required equipment/Tools
.
Personal computer (PC)
.
LAN cable (cross cable)
n
When using a straight cable, connect the unit to the PC
through a HUB that is not connected to any other
networks.
.
Software “RZ25MacSer.exe” for writing MAC address
and serial number: J-6433-410-B
n
Make sure to make a copy of the software
“RZ25MacSer.exe” for writing MAC address and serial
number in an arbitrary folder in the PC beforehand.
.
Power supply for the unit: 24 V AC or 12 V DC
Connection diagram
Network port
LAN cable
(straight)
LAN cable
(straight)
LAN cable
(cross)
Camera
Personal computer
Hub