Sony DWT-B30, Руководство по обслуживанию

Страница: 43 / 98

4-11 (E)
DWT-B30
4-2-4. RF Remote Performance Check
After repairing or replacing the RM-215 board, perform the operation check in the following flow.
If the operation is not smooth, a failure in the following path may have occurred.
IC402 (Main CPU)/DPR-396 board
→ IC2000 (CPU for REMOTE)/RM-215 board → IC2001/RM-215
board → CN2002/RM-215 board → CN002/LED-498 board → ANT1/LED-498 board)
n
If the paring is performed for the check procedure, the user’s pairing information is deleted.
When the DWR-R02DN is used for the check, the communication is performed with DWT-B03R. There-
fore, if the firmware version is V1.18 or earlier, update it to the latest version.
&
For the operation procedure, refer to the Operating Instructions.
Replacement procedure of RM-215 board: Refer to Section 3-2-8.
Abnormality exists between
IC402 and IC2000.
ĺ$IWHUSHUIRUPLQJWKH
check or repair, go to 1 .
1 Check the version
information.
Is the version displayed?
Displayed
No
Not displayed
2 Check the RF
remote control ID.
Is the RF remote
controller ID set to
“FFFFFFFFFFFFFFFF” ?
3 Perform the pairing
and check the remote
operation.
Go to the next page
Normal
Go to the next step.
Normal
Go to the next step.
Yes
The EEPROM data in IC2000
on the RM-215 board is lost.
ĺ$IWHUUHSODFLQJWKH
RM-215 board, go to
1
.
START
Operation
1 -1 Enter the test mode. (Refer to Section 1-5.)
1 -2 This unit; REMOTE VERSION menu
DWR-R02DN/R03D; The RF remote version
is displayed on the top screen of test mode.
Operation
2
-1 Enter the test mode. (Refer to Section 1-5.)
2 -2 This unit; INTERNAL MAC menu
DWR-R02DN/R03D; Your RF remote control
ID is displayed in the MAC ADDRESS menu.