Sony CMT-SP55TC, Руководство по обслуживанию

Страница: 84 / 160

14
SECTION 7
DIAGRAMS
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed
in each block.)
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
f
: internal component.
• 2 : nonflammable resistor.
•
5
: fusible resistor.
•
C
: panel designation.
For printed wiring boards.
Note:
•
X
: parts extracted from the component side.
•
Y
: parts extracted from the conductor side.
• b : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
•
U
: B+ Line.
•
V
: B– Line.
•
H
: adjustment for repair.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
E
: PB
a
: REC
• Abbreviation
AED : North European model
MY : Malaysia model
SP : Singapore model
Note: The components identified by mark
0
or dotted line
with mark
0
are critical for safety.
Replace only with part number specified.
• Indication of transistor
C
B
These are omitted.
E
Q
B
These are omitted.
C E
B
These are omitted.
C E
• WAVEFORMS
– MAIN BOARD –
250Vp-p
2
T501
4
REC MODE
3
T501
5
REC MODE
65Vp-p
125nsec
1
IC701
w;
XOUT
4.5Vp-p
11.7
µ
sec
11.7
µ
sec