The MD Deck — Recording
31
Marking track numbers
You can mark track numbers as follows:
•
Automatically during recording
Track numbers are automatically marked as on the
original source during recording from this
system’s CD player or components connected to
the DIGITAL OPTICAL AUX IN jack. Use the
Level Synchro Recording function to
automatically mark track numbers during
recording from this system’s tuner, the optional
tape deck or components connected to the AUX
IN jacks.
•
At any point during recording
You can mark track numbers while recording any
sources.
•
After recording
Use the Divide function (see page 42).
Marking track numbers
automatically during
recording
— Level-Synchro Recording
The Level Synchro Recording function is factory
set to on, so the track numbers are automatically
marked. If “LEVEL-SYNC” does not appear
during recording, turn on the Level Synchro
Recording as follows. Track numbers are
automatically marked when the input signal is
continuously below a certain level for more than
two seconds and then exceeds that level.
Note
You can not mark track numbers automatically if the
sound source to be recorded is noisy.
2,3
1,4
1,2,3
1
Press MENU/NO during recording
pause to display “MD Setup ?”, then
press ENTER/YES.
2
Turn
l/L
until “MD T.Mark
Off” (or “MD T.Mark LSync”) appears,
then press ENTER/YES.
3
Turn
l/L
until “MD T.Mark
LSync” appears, then press ENTER/
YES.
“LEVEL-SYNC” lights up.
4
Press MENU/NO.
Cancelling automatic track
marking
1
Press MENU/NO during recording pause.
“MD Setup ?” appears, then press ENTER/
YES.
2
Turn
l/L
until “MD T.Mark LSync”
appears, then press ENTER/YES.
3
Turn
l/L
until “MD T.Mark Off”
appears, then press ENTER/YES.
“LEVEL-SYNC” disappears.
4
Press MENU/NO.
When “LEVEL-SYNC” is off, a track number is
marked only at the beginning of each recording.
continued
