19
US
Setting up the Main Unit
Selecting the Source and the Volume Level
of the Main Unit
Selecting the source for each zone
In the NORMAL mode, you can select a source
component for each zone. The status information for each
zone appears on the display window.
1
Select a zone by pressing the ZONE + or ZONE –
button.
2
Select a source component by pressing the SOURCE
or SOURCE SELECT – button.
The source component is confirmed one second after
you release the SOURCE SELECT button.
Example 1: When a source component connected to the
SOURCE 1 Out/In plugs is selected in ZONE 1.
Example 2: When you connect a source component
whose title has changed from SOURCE 1 to
DVD in the PC SETUP mode.
Tip
Even when you connect several DVD players to the Main
Unit, you can distinguish each of them by the source number
displayed on the far right side in the display window.
Z
O
N
E
1
:
S
O
U
R
C
E
1
ZONE
SOURCE Title
SOURCE No
1
Adjusting the volume in each zone
1
Press ZONE+ or ZONE – repeatedly to select a zone.
2
Press ZONE or VOLUME – to display the
current volume level.
The display window changes as shown below.
t
VOLUME
MIN
VOLUME
1
VOLUME
73
t
VOLUME
MAX
Note
The volume level displayed in the display window varies
depending on the volume limits you have set as described in
“Setting volume limits” on page 29.
3
Press ZONE or VOLUME – repeatedly to
adjust the volume to the desired level.
The display window returns to the NORMAL mode in
a few seconds after you have finished.
Note
In a zone where SOURCE INPUT OFFSET is ON, the actual
volume level is lower than the displayed volume level (page
24).
Turning ALL ZONE MUTING on or off
1
Press ALL ZONE MUTING on the Main Unit.
“ALL ZONE MUTING” appears in the display
window, then the display window returns to the
previous display.
2
To turn ALL ZONE MUTING off, press ALL ZONE
MUTING again.
“MUTING OFF” appears for a few seconds, then the
display window returns to the previous display.
…
r
