4-40
DSR-300/P(E)/V1
19. Remove the stopper washer shown in the figure,
and remove the mode slider.
Attachment
20. Attach the new mode slider in the reverse order
of step 19.
21. Attach the parts removed in the reverse order of
steps 1 to 18.
22. Adjust the phase as follows.
1) When attaching the cam gear and threading
gear, insert the reference pin into the hole of
each gear shown in the figure, and adjust the
phase.
2) At the same time, make sure that shaft
a
of
the slider arm should be seen from the long
hole of the cam gear.
Adjustment
23. Perform tape guide height check/adjustment.
(Refer to Section 4-37.)
24. Perform the capstan FG DUTY adjustment at
Menu M601. (Refer to Section 8-1.)
25. Perform REV rewinding torque check/
adjustment. (Refer to Section 4-38.)
26. Perform TR arm assembly position check/
adjustment. (Refer to Section 4-40.)
27. Perform FWD back tension check/
adjustment.(Refer to Section 4-39.)
28. Perform tape path check. (Refer to Section 5-3.)
29. Perform tracking adjustment.
(Refer to Sections 5-4 to 5-7.)
30. Perform switching position adjustment.
(Refer to Section 5-8.)
Stopper washer
Mode slider
Shaft
a
(Slider arm)
Threading gear
Shaft
a
should be seen.
HC gear
Inserting hole for reference pin
Long hole
Inserting hole for reference pin
Cam gear
