Sony Ericsson CM52, Руководство пользователя

Страница: 128 / 158

Confidential
USERS MANUAL 128(158)
Document number Revision
1/198 17-4/FCP 101 3045 Uen D
Description Syntax Possible responses
Reads the last transmitted digit
buffer AT*EDSDG?<CR> *EDSDG: <ascii_string>
This command permits the serial port host to create and send a MicroBurst digit buffer. The module accepts,
stores and transmits data with a single command. Binary data must be converted to its decimal equivalent
before sending it to the module. For example, the MicroBurst digit buffer is ready for transmission (including
prefix digits of *9, as applicable) without any modifications by the module. The module accepts the
<dial_digits> string, converts it to hex nibbles, stores it in the digit buffer of the MicroBurst, and initiates an
origination.
The * prefix MUST be presented in the command. A minimum of 15 and a maximum of 31 dial digits must also
be included.
Note: When authentication is active, an error is indicated if the length of the buffer exceeds 24
characters and transmission is attempted.
Parameter Description
<dial_digits>
0..9,*,# String – the digits that are represented on a telephone keypad.
The AT*EDSDG command will return ERROR if the feature required for this function is not enabled. Feature
required for this command:
o
Aeris Microburst
5.2.9 AT*EDRDG Read Current Dial Digit Buffer State
Description Syntax Possible responses
Reads the contents of the
dialed digit buffer. AT*EDRDG?<CR> *EDRDG: <dial_digits>, <status>
The contents of the MicroBurst digit buffer are returned to the serial port host. The <dial_digits> is prefixed with
*. For example, *900001751230045, 1. A power-on cycle sets the contents of the dial digit buffer to a default
value.
Parameter Terse Description
<dial_digits>
0..9,*,# String – the digits that are represented on a telephone keypad.
<status>
Default 1 Buffer contains primary MIN.
Armed 2 Buffer contains new data.
ACKed 3 Buffer transmitted and acknowledged (SAT detected).
NACKed 4 Buffer transmitted but not acknowledged (SAT not detected).
Pending 5 Buffer queued for transmission (global page).
TX Error 6 Transmission incomplete due to DISABLED or QUIET mode, or
invalid reach-back character
The AT*EDRDG command will return ERROR if the feature required for this function is not enabled. Feature
required for this command:
o
Aeris Microburst