Sonnenkonig KLIMA KING Plus, Руководство пользователя

Страница: 63 / 71

63
EN
System «A» is more commonly used and the drain
pipe goes outside where there is no problem to
connect or drain it, this solution is OK for hot coun-
tries and normal cold temperatures outside.
System «B»: If it is not possible to install the drain
pipe as in system «A», please use system «B» to
drain the condensate moisture to a suitable place.
If you use system «B», please do not remove the
black rubber cup from system «A».
Normally the «B» opening is used for installation
when the outside temperature is very low, this pre-
vents ice from forming in the water drainage pipe.
This solution is also used to make it easier for the
installer to connect the internal drain pipe when he
does not want to see the pipe from the outside.
Fixing the bracket
Drill the holes for anchoring the mounting bracket to
the wall preferably in the 6 holes shown in black on
the paper template. If the wall is not stable enough, it
is advisable to use additional anchor bolts by using
the holes marked in grey on the paper template.
The anchor bolts supplied require 8 mm holes: The
wall should be inspected to determine if the supplied
bolts are useful or if another anchorage must be
used. The manufacturer is not liable if the structural
consistency of the anchorage is underestimated du-
ring installation.
160 mm Ring 150 mm Ring
Installing the pipes
After you have drilled the holes, you must put the
plastic sheet supplied with the air conditioner
through the holes.
Measure the depth of the wall and cut the plastic
sheet provided. Roll up the sheet and insert it into
the hole, paying attention to the joining line, which
must always be at the top. Remember that the panel
must have the same inclination as the holes (at least
3°). Insert the rings into the holes.