Sonnenkonig KLIMA KING Plus, Руководство пользователя

Страница: 62 / 71

62
EN
Wall Drilling
Please note: If you are drilling the hole above ground
level, please ensure that one area is secured and the
outside area is monitored during drilling until the
hole is completed.
Inlet and outlet holes
This operation should be carried out with the fol-
lowing tools suitable tool (diamond drill or core drill
with high torque and adjustable speed).
Fix the template to the wall, making sure that the
distance to the floor or ceiling is maintained.
Mark the centre of each core hole to be drilled with a
pilot drill.
Use a 162 mm diameter core drill to drill the two
holes for the air inlet and outlet.
It is recommended that the holes demonstrate a
slight downward slope of 3-5 degrees to prevent
backflow of water from the two pipes.
Drain pipe
This air conditioner has a double system for automa-
tic condensate moisture drainage. Before installing
the air conditioner, select the system that is suitable
for you. Please read the following instructions care-
fully.
System «A»: Drill a 30 mm diameter hole in the wall
at the location indicated in the paper template. Drai-
nage is by gravity. For this reason, it is important that
the drain pipe has a downward slope of at least 3 de-
grees along its entire length: Connect the drain pipe
(from the rubber clamp) to the air conditioner (back)
after removing the black rubber shell. This solution
allows you to drain the condensation moisture to a
suitable place so as not to cause problems for your
neighbours.
If you use system «A», please do not pull the black
rubber cup from system «B».
3-5 °
Innen Aussen
weiches Terminal
hartes terminal