8
Redbox RB-DSD8 User Handbook
Remote Start Mode Switch (DIPSwitch 7, Bank 2)
This defines whether the remote start switch is momentary or latched. Used for starting
external equipment when silence is detected on channel 1. The channel can be reassigned
through the serial port.
DIPSwitch 7
Description
On
When off, the remote start pin on the remote connector is pulled low
when the unit switches over to the backup input and remains low until
the unit switches back to the main source or, if in manual mode, is
restored by the user locally or remotely. (Latched contact).
Off
When on, the remote start pin (pin 7) on the remote connector is pulled
low for half a second when the unit switches to the Backup input.
(Momentary contact).
Loss of Lock Failure (DIPSwitch 8, Bank 2)
This defines whether the unit treats a loss of synchronisation lock as an immediate switch
event or as a simple loss of level.
Note: Switch this to ‘Off’ when using an analogue input.
DIPSwitch 8
Description
On
When on, the unit treats the loss of lock condition as an immediate
switch event. The unit switches immediately to the Backup input.
Off
When off, the unit treats the loss of lock no differently to a loss of level.
Output Pair Configuration (DIPSwitches 9-12, Bank 2)
These DIPSwitches allow you select whether each output pair is analogue or digital. Set
each DIPSwitch so that:
DIPSwitch 9 - 12
Description
On
When on, the pair outputs a balanced analogue signal.
Off
When off, the pair outputs an AES/EBU digital signal.
DIPSwitch 9 = Channel Pair 1 & 2
DIPSwitch 10 = Channel Pair 3 & 4
DIPSwitch 11 = Channel Pair 5 & 6
DIPSwitch 12 = Channel Pair 7 & 8
Rear Panel DIPSwitches: Bank 3 MISC SETTINGS
Ignore Silence Settings (DIPSwitches 1-8, Bank 3)
Each channel has a DIPSwitch to determine whether it Is ignored when AUTO silence
switching.
REAR PANEL DIPSWITCH SETTINGS
3
REAR P
ANEL DIPSWIT
CH SE
T
TINGS
