22
Zone address setting
You can set the sensor as “ Door “ or “ Window “ detector by using the jumper selector and follow the
marked. Ex. You want to set the sensor as Door sensor, put the Jumper on marked “D” side. (If set
Jumper on marked “W” side, the sensor becomes as Window sensor).
DOOR
DOOR / WINDOW
SELECT
JUMPER
TYPE SEL
WINDOW
DOOR / WINDOW
SELECT
WINDOW
DOOR
JUMPER
TYPE SEL
DC 12V
DC 9V
Notes on the Door/Window Detector
1.
The LED on the sensor will flash once when the sensor is triggered.
2.
There cannot be a gap greater than 1/4 inch (5 mm) between the magnet sensor and the magnet,
otherwise, the sensor will not work properly.
Enter the installer password and let main console in learning mode. take magnet away from magnet
sensor, it will trigger the sensor and LED will light on for 1 sec. the Main Console emits one ‘Beep’ and
LCD displays ‘Sensor Added’, it means sensor has learned into the system successfully.
LCD display on the Main Console for Door/Window Detector
When system is in armed mode.
(message shown on main console)
l
Window opened
Door opened
When system is in disarm mode.
(message shown on main console)
l
Window closed
l
Window battery cover opened Door battery cover opened
63 WINDOW SENSOR
01
Open
63 DOOR SENSOR
01
Open
63 WINDOW SENSOR
01
Close
