10
When finished recording message, it will automatically playback recorded message one
time and LCD panel shown as below.
(4) 8 – DIAL
: To set Dial mode. (default is 2-ALL to dial all telephone sets)
Press 1 for single attempt dial. ( if one of the telephone set is acceptable, it will stop to
dial other’s telephone set)
Press 2 for 3 cycles attempt dial.( it will be in turn to dial all the telephone set, when the
phone number is dial out and has been picked, the picked number will stop to dial)
(5)
9 – CODE
: To make password change. (factory defaults, 1-Install :123456, 2- Master : 135246). If
you want to change the password, key-in 6 digits and will automatically show
“OK”( max set 6 digits), if the word if less than 6 digits, you can press ENTER
after key-in the number and it will show ”OK”.
Press 1 and in the change Install code menu.
Press 2 and in the change Master code menu.
1- SEQ
: " Sequent" for code learning to set zone location . First of all, all the sensors
need to be learned into main console and main console can receive the
signal if the sensor is triggered. When sensor is learned into main console,
main console will set the learning order for the sensor. This system allows
Setting : Dialer Mode
1 – Single 2 – All 1
Setting : Change Code
1 – Install : 1 2 3 4 5 6
Setting : Change code
2 – Master : 1 3 5 2 4 6
Setting : Message Play
Sel Msg
: 1 25 Sec
Setting : Dialer Mode
1 – Single 2 – All 2
Setting : Change Code
1 – Install 2 – Master
Setting : Dialer Mode
1 – Single 2 – All 2
2
