11
to set Zone numbers maximum to 63 addresses. It is recommend that you
use a pen on the sensor back label to mark the sensor location, You can
also replace or clear sensor for changing sensor.
In the system menu,
Press 1 and into the sequential programming mode
( 01 sensor learning order)
The method for sensors learning
:
1.
PIR Motion Detector :
First install Battery and push the Power Switch from OFF to C position. PIR sensor LED will
light on for 1 Sec, it means that the sensor transmit 1 sec signal. Or you can move in the
front of PIR, It will detect your movement and transmit 1 sec signal. The sensor will be
learned into main console.
2.
Door / Window Detector :
First to install Battery and let the magnetic switch from close to open, the led will light on for
1 Sec, The sensor will be learned into main console.
3.
Remote Control handset :
First to install Battery and press PANIC button, the led will light on for 1 Sec, The
sensor will be learned into main console.
4.
Panic Watch :
First to install Battery and press RED button, the led will light on for 1 Sec, The sensor
will be learned into main console.
5.
Smoke Detector :
First to install Battery and press S1 button, the led will light on for 1 Sec, The sensor will
be learned into main console.
6.
Gas Detector :
Plug the AC power and press the TEST button, the led will light on for 2 Sec, The sensor
will be learned into main console.
7.
When the sensor is learned into main console, It will show the message as below. At the
time it will automatically switch to next sensor learning mode
8.
If the sensor has been learned in main console. Main console will show the sensor has
been learned in memory and not allow same sensor to learn into main console.
Sequential Pgming
Trigger Sensor 01
SYS_OPTS: 0-SYS_OPTS
1 – SEQ 2 – REPLAC 3 – CLR
Sequential Pgming
Sensor Added
Sequential Pgming
Trigger Sensor 02
Sensor Already
Exists in System 02
