LT-30RT Round Head
Roll Up WireFree RTS Programming & Operation Instructions
TM
my
Press and
hold UP &
DOWN Button
For Single Channel Transmitters (Telis 1, Decora 1, or Chronis Timer)
1) On the transmitter, press and hold the
UP
and
DOWN
uttons
simultaneously
until the shade jogs (shade has a short up and down movement).
For Multi-Channel Transmitters (Telis 4 or Decora 4)
1) Using the channel selector, select the desired channel.
2) On the transmitter, press and hold the
UP
and
DOWN
uttons
simultaneously
until the shade jogs.
b
b
STEP ONE
STEP TWO
Initiate Programming – (for use with Telis 1 & 4, Decora 1 & 4 or Chronis Timer)
Telis 1 Transmitter
Decora 1
Chronis Timer
UP Button
MY (stop) Button
DOWN Button
Channel Selector
Telis 4 Transmitter
The following illustrations and instructions represent the Telis
hand-held remote, and may also be applied to the Decora
wireless wall switch and Chronis Timer.
1) Connect 12V battery wand or transformer to the motor.
Motor should already be installed in shade.
Connect Power to Motor
Programming Instructions are for use with Telis 1&4, Decora 1&4 or Chronis Timer
NOTE: This step cannot be performed if the transmitter has already been programmed
(memorized) to shade.
Before you begin
Motors are shipped without limit switch settings and transmitter ID’s
Steps (1-6) must be completed to ensure proper shade programming
and functionality. It may be necessary to disconnect shades from their
respective power while programming is in progress. While programming
(step 4), shade should not be inactive for longer than 2 minutes
or motor will exit programming mode.
