4
GB
Fitting the rail onto the motor head (Fig. 7)
Fitting the complete assembly onto the garage ceiling (Figs. 8 to 10)
Fitting to the lintel bracket (Fig. 8)
Ceiling mounting
. Flush with the ceiling: mount the system directly onto the ceiling using the rail
(Fig. 9)
.
It is possible to add mounting points at the motor head level (
Fig. 9
-
-
).
. Hung from the ceiling
(Fig. 10)
Intermediate mounting points can be added to the rail, especially in the case of a two part rail or a rail that measures 3.5M in length (
Fig. 10
-
-
).
Fitting the arm onto the door and the trolley (Fig. 11)
[1].
Release the trolley using the manual release cord
[2].
Bring the trolley up to the door
[3].
Attach the arm to the door bracket and the trolley
Fastening and adjusting the travel stops (Figs. 12 and 13)
Close travel stop
(Fig. 12)
[1].
Release the trolley from the runner using the manual release mechanism and bring the door to the closed position.
Fully close the door.
[2].
Position the close travel stop against the trolley and attach it to the rail.
Open travel stop
(Fig. 13)
[1].
Release the trolley from the runner using the manual release mechanism and bring the door to the open position.
Do not open the door fully, but position it so that it does not reach the travel stops.
[2].
Position the open travel stop against the trolley and attach it to the rail.
Note: The stop positions can be set by positioning the door open or closed using the forced operation mode
(Fig. 39)
.
Fitting the chain retainer pads (Fig. 14)
For chain rails only.
Position the chain retainer pad into the first hole in the rail after each travel stop.
Be sure to press the pad all the way down so that the positioning pin sticks out from the rail.
Make sure that the manual release cord is located at a maximum height of 1.80 metres off the ground. If necessary, extend
the cord.
Checking the chain or belt tension (Fig. 15)
Dexxo Pro is supplied with the tension preset and checked. If necessary, adjust the tension.
The rubber or tension spring must never be full compressed during operation.
Connecting the mains power supply (Fig. 16)
[1].
Remove the motor cover and the protective sheet.
[2].
Fit the light bulb.
[3].
Connect to the mains supply.
Plug the power cable into a suitable power outlet that complies with electric power requirements.
The electric supply must be suitably protected (a fuse or circuit breaker with a 5 A rating) and a residual current device
(30 mA).
An omnipolar disconnection mechanism must be provided for the power supply:
. by using a power cord with a mains splug that can be disconnected, or
. by fitting a switch that ensures a contact separation distance of at least 3 mm for each pole (refer to standard EN60335-1)
5048551A-GB 26/04/07 14:36 Page 4
www.garagedoorsonline.co.uk
01926 463888
www.garagedoorsonline.co.uk
www.garagedoorsonline.co.uk
01926 463888
www.garagedoorsonline.co.uk
