SOMFY Axovia-220B, Руководство по установке

Страница: 4 / 24

2
This Somfy product must be installed by a professional motorisation and home automation installer, for whom this guide is intended.
This product, installed in accordance with this guide, complies with EN 12453 and EN 13241-1 standards. It is the installer's responsibility to ensure
that the automatic installation and its operation are compliant with the standards in force.
The use of any safety components not approved by Somfy remains the sole responsibility of the installer. The selected safety accessories for the
installation must comply with the current standards and regulations in force in the country in which the product is being installed.
Moreover, the installer must comply with current standards and legislation in the country in which the product is being installed, and inform his customers of the
conditions for use and maintenance for the product.
Any use outside the sphere of application specified by Somfy is forbidden. This invalidates the warranty and discharges Somfy of all liability, as does any failure
to comply with the instructions given herein.
Hereby, Somfy declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A declaration of
conformity is available on the website at www.somfy.com/ce (AXOVIA 220B), usable in UE, CH and NO.
GENErAl iNfOrmATiON
SAfETy
Safety instructions
Important safety instructions. Follow all the instructions as incorrect installation can lead to serious injury.
This device is not designed to be used by persons (including children) whose physical, sensory or mental capacity is impaired, or persons with little experience or
knowledge, unless they are under supervision or have received instructions on using the device by a person responsible for their safety.
Check that the temperature range marked on the motors is suited to the location where the motors are to be installed.
Before installing the motor, ensure that the driven part is in good mechanical condition, that it is correctly balanced and that it opens and closes correctly.
The motor cannot be used with a driven part incorporating a small gate (unless the motor is inhibited when the small gate is opened).
Ensure that there are no danger zones (risk of crushing, cutting, trapping) between the gate and the surrounding fixed elements caused by the opening movement
of the gate.
Watch the gate while it is moving.
Place the fixed control devices and remote controls out of the reach of children.
Any switch without a locking device must be installed in direct view of the gate and away from any mobile parts. Unless it is key-operated, it must be installed at
a minimum height of 1.5 m and must not be accessible to the public.
During installation of the motorisation:
Remove any jewellery (bracelets, chains, etc.). -
For drilling and welding operations, wear special glasses and sufficient protection.
-
Use the appropriate tools. -
Do not connect to the power source until installation is complete.
-
Be careful when handling the motorisation system to prevent any risk of injury. -
After installation, ensure that the mechanism is correctly adjusted and that the protection system and any manual release mechanism operate correctly.
Regularly check the condition of the gate. Gates in poor condition must be repaired, reinforced or even replaced. Check that the various motorisation component's
screws and fittings are correctly tightened.
Before carrying out work on the installation, switch off the power supply.
In order to operate, the motor must be supplied with 230 V -50 Hz. The electric line should:
- solely be used for the motor,
- have a minimum cross section of 1.5 mm²,
- be equipped with protection (10 A fuse or breaker) and a differential device (30 mA),
- be equipped with an all-pole disconnection device,
- be installed in accordance with the current electrical safety standards.
It is recommended that the installation be fitted with a lightning conductor (in compliance with standard NF C 61740, maximum residual voltage 2 kV).
All 230 V lighting connected to the “zone lighting” output must be connected to earth or be of the double isolation type.
5101723A_Axovia-220B.indd 2 10/05/2011 15:37:50