SOMFY Axovia-220B, Руководство по установке

Страница: 15 / 24

13
OPErATiON
AdvANCEd PArAmETEr SETTiNG
Adding and removing remote controls
To clear all the programmed remote controls
Press the reset push button located above terminal 1 of the electronic unit for
7 seconds.
when pressing the button, the 4 indicators will go out, and indicators 1 and 4
will come on again. All the programmed remote controls will be erased.
To add a remote control after the first programming phase
[1]. Proceed as with the initial programming phase of a remote control in full
opening mode only or pedestrian and full opening mode (see page 12).
[2]. Programme the gate travel again as programming a new remote control
cancels the gate travel programming (see page 12).
It is not possible to store more than 16 transmitters.
delete all the remote controls and resume
programming.
To change the operating mode of a remote control that is
already programmed,
Start the remote control programming procedure over again (see page 12).
The most recent mode stored clears the previous mode stored.
According to the programming of the remote controls, the gate will open either fully only (full opening only mode), or for pedestrian access or fully (pedestrian or
full opening mode).
The motor can operate in Sequential mode or Automatic Closure mode.
Sequential mode
: successive presses of the same remote control button will lead to the following movements: Open, Stop, Close, Stop, Open etc.
Automatic closure mode : pressing the programmed button of the remote control will cause the gate to open. The gate will close automatically after a time
delay. The length of the time delay before closing can be adjusted.
The gate can be held in the opened position by giving a stop command during the time delay. To close the gate, press the remote control button again.
For more information, refer to the user section.
Activating the Automatic Closure mode
By default, the motor will be in sequential mode.
the automatic closure mode can only be activated if a set of photoelectric cells has been fitted, as well as an amber
light and area lighting.
[1].
Place a programmed remote control on the target engraved on the cover. Indicator light 2 is off.
[2]. Press and hold the programmed button of the remote control until indicator 2 comes on.
[3]. Release. Indicator 2 flashes.
[4].
Initiate opening using the transmitter.
[5]. Once the gate is completely open, wait the time required before automatic closure, then press the remote control button to send the close command. Indicator
2 will light up continuously.
Switching to sequential mode after activating Automatic Closure mode
[1]. Place a programmed remote control on the target. Indicator light 2 is on.
[2].
Press and hold the programmed button of the remote control until indicator 2 goes out.
[3]. Release. Indicator light 2 is off.
5101723A_Axovia-220B.indd 13 10/05/2011 15:38:32