SOMFY Axovia-220B, Руководство по установке

Страница: 19 / 24

17
diAGNOSTiC ANd rEPAirS
Problems Solutions
Led 1 does not come on when switching on Check the mains power supply.
-
Check the supply cable. -
Check the fuse
-
Led 3 remains on permanently This signal indicates a cell fault. Check:
the cell alignment
-
the cell cables -
the cell power supply
-
that the cells are recognised in automatic mode
-
if there is no permanent control on inputs 5 or 6 of the circuit -
Led 1 flashes slowly The force required of the Axovia is too much. Check the gate matches the area of application.
Led 1 flashes quickly Short circuit detected on the motor output. Rewire the motors to eliminate the short circuit.
-
The electronics are overheating, wait 5 minutes before sending a new command. -
The transmitter range is reduced Check that the position of the original aerial is in line with the instructions given on p. 8.
-
Check the transmitter batteries. -
Environmental disturbance (electric pylon, metal walls etc.). Use an outside aerial.
-
For vehicles with air conditioning fitted with a metallic windscreen: point the remote control at the black strip -
on the windscreen or point through the untreated side windows, or through an open window.
Indicators Led 1, Led 2, Led 3 and Led 4, located under the motor cover, are used to give fault finding indications.
5101723A_Axovia-220B.indd 17 10/05/2011 15:38:40