SOMFY Axovia-220B, Руководство по установке

Страница: 23 / 24

3

uSE ANd OPErATiON
default operation in sequential mode
By default, the gate will operate in sequential mode.
Depending on the programming carried out by the installer, the gate can operate either in full opening mode only (systematic opening of both gate leaves), or
in full or partial opening mode (pedestrian mode). In this case, a long press on the remote control button triggers full opening, and a brief press triggers partial
opening of the gate.
Short press
"full opening" operation (fig. 1) •
1
STOP
STOP
p p p p p p
p p p
p p p
p p p
2
"Partial opening" operation (fig. 2) •
Obstacle detection operation •
When an obstacle is detected during opening, the gate will stop. Pressing the programmed button on the remote control will make the gate move in the opposite
direction.
When an obstacle is detected during closing, the gate will stop and reopen automatically. If the obstacle is detected in the last 50 cm of travel, the gate will stop
and not reopen.
Operation in Automatic Closure mode
If the Automatic Closure mode has been programmed during installation, the gate will operate as follows.
Pressing the programmed button of the remote control will cause the gate to open. It will close automatically after a delay time that was defined when activating
the Automatic Closure mode.
It is possible to keep the gate in the open position by briefly pressing on the programmed button on the remote control during the time delay. Pressing the button
on the remote control again will close the gate immediately.
Operation with safety cells •
Gate open: an obstacle placed between the cells will inhibit closing of the gate as the cells have detected a presence.
Gate moving:
If an obstacle is detected while the gate is opening, the gate will continue moving (cell status not recognised).
If an obstacle is detected when closing, the gate will stop for 1 second and then reopen automatically.
Operation with orange flashing light •
The orange light is activated during any movement of the gate with a 2 second warning.
Specific operation
Depending on the peripherals installed and the operating options programmed by your installer, the motor may have the following specific functions:
manual back release
In case of a power cut, the manual back release device makes it possible to
open the gate.
Unlock the motor arms by turning the button located underneath the motors.
Padlock closed: arm locked; padlock open: arm unlocked, manual operation.
Long press
p p p
In unlocked position, move the arms slowly to avoid
damaging the motors.

5101723A_Axovia-220B.indd 3 10/05/2011 15:38:43