The programming screen should now look like this:
The first step in programming is to locate the node id. The
8 digit ID located on the top of the motor controller, illustrated right. The last 6 digits of this
is the MoCo base address in decimal. Note, communication must be done with the hexadecimal
conversion of this address. To find the hexadecimal equivalent open the calculator on your pc.
Choose view and make sure calculator is set to scientific (Figure 1). With the decimal check box
selected enter in the last 6 digits of the ID located on the motor controller. To obtain the
hexadecimal (hex) equivalent simply select the “hex” check mark and the ID will now be displayed
in hex (Figure 2).
Note, the ID displayed in Figure 2 has 5 digits instead of 6. Zero’s are not displayed in the first digit location. When
entering this ID into the programming software, enter 06DA6B.
Motor Controller Addressing:
Figure 1
Figure 2
