©2020 Solwave ovens
Lancaster, Pennsylvania,17603
Page 4 of 16
Part No. 20152604
Original Instructions
Grounding/Earthing Instructions
Oven MUST be grounded.
Grounding reduces risk of electric shock
by providing an escape wire for the electric current if an electrical
short occurs. This oven is equipped with a cord having a grounding
wire with a grounding plug. The plug must be plugged into an outlet
that is properly installed and grounded.
Consult a qualified electrician or servicer if grounding instructions are not
completely understood, or if doubt exists as to whether the oven is properly grounded.
Do NOT use an extension cord.
If the product power cord is too short, have a qualified electrician install a three-slot receptacle. This oven should be plugged into
a separate circuit with the electrical rating as provided in product specifications (available on Solwave’s website at
www.solwaveovens.com) and the oven’s serial plate / rating label. When the oven is on a circuit with other equipment, an
increase in cooking times may be required and fuses can be blown.
EXTERNAL EQUIPOTENTIAL EARTHING TERMINAL
(export only)
Equipment has secondary earthing terminal. Terminal provides external earthing connection used in addition to earthing
prong on plug. Located on outside of oven back, terminal is marked with symbol shown at right
Installation
Unpacking Oven
• Inspect oven for damage such as dents in door or inside oven cavity.
• Report any dents or breakage to source of purchase immediately.
Do NOT attempt to use oven if damaged.
• Remove all packing materials from oven interior.
• If oven has been stored in extremely cold area, wait a few hours before
connecting power.
•
A protective film is used to prevent scratching of the outer case during
transportation. Peel off the film from the exterior of the oven before installation.
• The warning label provided with the oven must be placed in a conspicuous
location near the oven.
Radio Interference
Microwave operation may cause interference to WiFi network, radio, television, or a
similar oven. Reduce or eliminate interference by doing the following:
• Clean door and sealing surfaces of oven according to provided instructions.
• Place WiFi network, radio, television, etc. as far as possible from oven.
• Use a properly installed antenna on radio, television, etc. to obtain stronger signal
reception.
Oven Placement
• Do NOT install oven next to or above source of heat, such as pizza oven or deep
fat fryer. This could cause oven to operate improperly and could shorten life of
electrical parts.
•
Do NOT block or obstruct oven filters. Allow access for cleaning.
• Install oven on level counter-top surface.
• Outlet should be located so that plug is accessible when oven is in place.
OVEN CLEARANCES
A.
Allow at least 7” (17.78 cm) of clearance around top of oven. Proper air flow
around oven cools electrical components. With restricted air flow, oven may not
operate properly and life of electrical parts is reduced.
B. There is not an installation clearance requirement for the back of the oven.
C. Allow at least 1” (2.54 cm) of clearance around sides of oven.
D. Install oven so oven bottom is at least
3 feet
(91.5 cm) above floor.
⚠
WARNING
Excessive Weight Hazard
Use two or more people to move
and install oven. Failure to do so can
result in back or other injury
⚠
WARNING
To avoid risk of electrical shock or
death, this oven must be grounded
and plug must not be altered.
Grounding and Installation
A
B
C
D
A
D
B
C
A
B
C
D
A
D
B
C
