©2020 Solwave ovens
Lancaster, Pennsylvania,17603
Page 8 of 15
Part No. 20037909
Original Instructions
Programming Keys
Oven is shipped from the factory for single key programming. To change the
oven default to allow double key programming, see
User Option
section. To
change the amount of time or the power level for a preset key:
1. Open oven door.
• READY displays.
• If door is closed or STOP key is pressed before programming is
complete, changes are discarded and microwave exits programming
mode.
2. Press and hold key 1 for approximately 5 seconds.
• This begins programming mode.
• Microwave will beep and PROGRAM displays. Oven is in
programming mode.
3. Press key to be reprogrammed.
• Press two keys if reprogramming a double pad program.
• Power level and cooking time display.
• If power level does not display, microwave is set to full power.
4. Enter cooking time by using the number keys.
5. Press a power level key to change power level if desired.
6. Press START key to save new programming changes to the key.
• PROGRAM displays.
• If START is not pressed, changes will not be saved.
7. Press STOP/RESET key or close oven door to exit programming
mode.
Programming the Oven Control
Programming Multiple Stages
Stage cooking allows consecutive cooking cycles without interruption.
Up to four different cooking cycles can be programmed into a memory key.
To use stage cooking:
1. Follow steps 1 through 5 above.
2. Press TIME ENTRY key.
•
Display briefly shows the key number that is being
programmed and the stage number to the upper right.
• Display changes to cook time and power level for the next stage.
3. Enter cook time and power level as in steps 4 and 5 above.
• To enter another cooking stage for that key, press
TIME ENTRY key again.
•
Up to four different stages can be programmed.
4. Press START key to save new programming changes to the
key.
5. Press STOP/RESET key or close oven door to exit
programming mode.
The display shows
PROGRAM.
When set to single key or
double key programming,
the display will show
PROGRAM
when
programming keys for single or double
digit cooking sequences. To change the
oven’s default to allow either single key
or double key programming, see the
User
Option
section.
QTY X2
Programming
This feature allows a
preset percentage of original cook
time, called a cooking factor, to be
added to a cook sequence.
To change the cooking factor:
1. Open oven door.
2. Press and hold key 1 for
approximately 5 seconds.
3. Press key to be reprogrammed.
4.
Press the QTY X2 key.
5. Press a numbered key to change
the cooking factor.
• Cooking factor can be set from
10% to 100%.
• Default is 80%.
• Key 5 would change the cooking
factor to 50%.
• Key 3 would change the cooking
factor to 30%.
6. Press START key to save changes.
Canceling
Mistakes
If oven is not cooking, press
STOP/RESET key to clear display. If
oven is cooking, press STOP/RESET key
once to stop oven, then again to clear
display. If oven door is open and time
shows in display, close oven door and
press STOP/RESET key to clear display.
1
