SOLOY AVIATION SOLUTIONS
CESSNA 206 WITH WING MOUNT CAMERA
MAINTENANCE MANUAL SUPPLEMENT
ELECTRICAL POWER
24-00-00
ELECTRICAL POWER - GENERAL
October,
2011
Page 1
ELECTRICAL POWER – GENERAL
1. SCOPE
The Cessna wing mount camera allows for the electronic installation to be
customized to each installation. Each customized application has different
inspection, removal, installation, testing and adjustment procedures. This chapter is
intended to give a general overview of the electrical system and how the electrical
cables are routed throughout the aircraft for the Cessna wing mount camera
installation.
A. Switch and Circuit Breaker Panel
An camera master switch and a 40 amp circuit breaker are added as part of the
Cessna 206 wing mount camera installation. The avionics master switch activates
a relay that supplies power to all additional electrical devices installed for the wing
mount camera installation.
B. Wing Mount Camera Cables (Figure 1)
The make and model of the camera is customer dependant, but the basic routing
of the camera cable bundle is consistent for all aircraft. The cable bundle starts
at the camera and passes through wing access panel 510YBS. The cable then
loops around and travels down the leading edge of the wing into the left side of
the cabin area. Then the cable passes behind the head liner and down behind
the interior panel emerging into the cabin area at around fuselage station 124.
Refer to Figure 1 for an illustration of camera cable routing.
C. Optional Downlink Antenna
The make and model of the optional downlink antenna is customer dependant.
The antenna wiring passes through a small hole in the belly of the aircraft and is
routed to the equipment rack located on the baggage shelf.
2. TOOLS, EQUIPMENT AND MATERIALS
This paragraph remains unchanged from the Cessna 206 model Maintenance
Manual.