- 12 -
2.
Installation and Test
2.1.
Installation Method
You can install EZL-410 in the following steps.
Title
Item
Sub-item
Description
1.
Checking the
communication
environment
Check items
Network environment
3.1.4.
Serial port settings
3.1.4.
Application program to be
used
4.
2.
Connecting to the
network
Check method
Check if LINK LED is
ON.
1.3.4.
3.
Configuring the
environmental
variables
Configuration
method
Set by ezcfgmp, a utility
program for configuration
through the network.
3.1.
Setting in console
3.2.
By arp
(Temporarily set IP
address only)
Configuration
items
IP address related items
3.1.4.
Serial port related items
3.1.4.
Communication mode
(Decided depending on
application program)
5.
4. Application to the field
2.1.1.
Checking the Communication Environment
Before installing EZL-410, check the network environment where EZL-410 is to be
installed, including the followings matters:
IP address environment (local IP, subnet mask, gateway, etc.)
Serial port type of the equipment to which EZL-410 is going to be connected
(RS232)
Serial port items of the equipment to which EZL-410 is going to be connected
(baud rate, data bit, parity, stop bit)
Application program protocol to be used (TCP/UDP, server/client, SSL, etc.)
For application program protocol to be used, see “5. Normal Communication
Mode”.
