- 13 -
2.1.2.
Connecting to the Network
Connect EZL-410 to a hub that user want to connect.
2.1.3.
Configuring the Environmental Variables
When network connection is completed, configure the environmental variables such as
IP address related items, serial port related items, and communication mode related
items by ezcfgmp or console.
For environmental variable configuration, see “3. Configuring Environmental
Variables.”
2.2.
Test
You can perform test EZL-410 according to the following orders. The test method
described here is based on the assumption that the IP address of the PC is set to 10.1.0.2
and user uses an EZL-410-EVB that is an evaluation board for EZL-410.
2.2.1.
Changing PC IP Address
You can change the IP address of your PC as follows:
IP Address
10.1.0.2
Subnet Mask
255.0.0.0
Gateway IP Address 0.0.0.0
2.2.2.
Installing EZL-410
Connect the EZL-410 with the PC through the crossed LAN cable. (When connecting
through a hub, use a one-to-one cable for this connection.) If Link LED of the LAN is on,
the connection is OK.
2.2.3.
Connecting to Serial Port of PC
Connect the EZL-410 with the PC through the RS232 cable. And run a serial
communication utility – for example: Hyper Terminal or Tera Term Pro. And set the
configuration of the utility to [19200bps, 8 data bits, 1 stop bit, no flow-control] as same
as configuration values of EZL-410.
Then the preparation of test is completed.
