● Use the original box to repackage the inverter, seal with adhesive tape with the desiccant
inside the box.
● Store the inverter in a clean and dry place, free of dust and dirt. The storage temperature
must be between -40~158
°
F and humidity should be between 0 to 100%, non-condensing.
● Do not stack more than two (2) inverters high on a single pallet. Do not stack more than
2 pallets high.
● Keep the box(es) away from corrosive materials to avoid damage to the inverter enclosure.
● Inspect the packaging regularly. If packaging is damaged (wet, pest damages, etc.),
repackage the inverter immediately.
● Store inverters on a flat, hard surface -- not inclined or upside down.
● After 100 days of storage, the inverter and carton must be inspected for physical damage
before installing. If stored for more than 1 year, the inverter needs to be fully examined and
tested by qualified service or electrical personnel before using.
● Restarting after a long period of non-use requires the equipment be inspected and, in some
cases, the removal of oxidation and dust that has settled inside the equipment will be
required.
● Perform an annual visual inspection of the inverter box for signs of damage
● If the inverter has been removed from the box and then replaced, put desiccant packets in the
inverter wire box to ensure the internal components stay dry
● Power up the inverter with a DC power supply annually for 5-10 minutes
1.4 Inverter Storage
If the inverter is not installed immediately, please adhere to the storage instructions & environmental
conditions are listed below:
DO NOT STACK
MORE THAN
HIGH
2
1. Introduction
SAVE THESE INSTRUCTIONS – This manual contains important instructions for models:
S6-EH1P3.8K-H-US, S6-EH1P5K-H-US, S6-EH1P7.6K-L-US, S6-EH1P7.6K-H-US ,
S6-EH1P10K-US, S6-EH1P11.4K-US, that shall be followed during installation and
maintenance of the inverter.
4