Solidyne DX 816, Руководство пользователя

Страница: 18 / 29

Figure 10: Telecom channel
VERY IMPORTANT

USB2 CANNOT BE USED IF THE CHANNEL USB1 IS NOT
CONNECTED; since USB2 is slave. In order to use only one
USB channel, connect the channel “USB1”.

WHEN TWO DIFFERENT COMPUTERS ARE CONNECTED;
THE CHANNEL USB2 CANNOT BE AVAILABLE WHEN THE
COMPUTER CONNECTED TO USB1 IS POWER OFF. Usually
USB 1 is used with the air PC; which is 24 Hs operative.
3.2.1 Using the TELECOM channel
For this explanation, we define two modes of work:
A) A DJ or Talent that answer itself the callings
of the audience (small stations; also used
by many radio stations outside rush hour).
B) A producer/telephonist answer the calls.
3.2.1.1 Case A: A DJ or Talent answer the call-
ing of the audience
The mixer has a telecommunication channel that
manages up to 3 phone lines (one is a cell phone
linked by Bluetooth).
1) The DJ/Talent can manage the incoming calls
unassisted. When a calling incomes, the button
of that line blink with the ‘ring’ cadence.
2) To answer a call, press the correspondent
blinking button. The button will light in red. For
the case of cell phone, press the button CELL
PHONE [3] to answer.
3) If there are more than one line in red (waiting
in HOLD), when the fader is raised to on-air
zone all lines go on-air in conference.
4) When a call is answered, the TELECOM fader
[9] must be closed, in the position CUE [10]. In
this condition, the caller remains hearing the
program mix (the audio that is on-air), and the
audio from the phone line sends to the CUE
bus.
5) To talk to the line(s), press and hold the button
TALK [8]. While TALK is pressed the speakers of
the Control Room remains muted, staying the
monitoring on headphones.
6) The button TALK [8] is retained. With the main
fader in CUE position, the operator can talk
hands free. The caller listen on headphones
(since the loudspeakers remains muted to
avoid feedback loops).
7) If the main fader is into the zone labeled as
“HOLD”, the calling is HOLD waiting to be on-
air. The caller hears the PGM signal. In this
mode, the phone line is not send to CUE.
8) To put a calling on-air (or more callings in a
conference) raise the main fader [9] until
achieve the apropiate level on VU meters. All
lines that have the button pressed (red) will be
on-the-air.
9) To end a call first close the main fader and then
release the button of the line. For the case of
CELL PHONE [3] the call is transferred to the
cell phone, and can be re-taken by pressing
CELL PHONE once. To hang out the cell phone,
short touch the button BLUETOOTH [2].
3.2.1.2 Case B: The producers team or
telephonist answer the calls
1)
In the Production Room there will be two
phones “Phone-1” and “Phone-2”, each one for
a phone line in the console; and the mobile
phone.
Page 18 DX816 & DX822 - Broadcast mixing consoles SOLIDYNE